Jlg E300 Operator Manual Manuel d'utilisateur Page 96
- Page / 100
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
6-14 – JLG Lift – 3121214
3. The tightening of the nuts should be done in stages. Fol-
lowing the recommended sequence, tighten nuts per
wheel torque.
4. Wheel nuts should be torqued after first 50 hours of
operation and after each wheel removal. Check the
torque after the first 10 miles, 25 miles, and again at 50
miles. Check periodically thereafter.
6.6 SUPPLEMENTAL INFORMATION
The following information is provided in accordance with the
requirements of the European Machinery Directive 2006/42/
EC and is only applicable to CE machines.
For electric powered machines, the equivalent continuous A-
Weighted sound pressure level at the work platform is less
than 70dB(A)
For combustion engine powered machines, guaranteed
Sound Power Level (LWA) per European Directive 2000/14/
EC (Noise Emission in the Environment by Equipment for
Use Outdoors) based on test methods in accordance with
Annex III, Part B, Method 1 and 0 of the directive, is 104 dB.
The vibration total value to which the hand-arm system is
subjected does not exceed 2,5 m/s
2
. The highest root mean
square value of weighted acceleration to which the whole
body is subjected does not exceed 0,5 m/s
2
.
Ta b l e 6 - 1 2 . W h e e l To r q u e C h a r t
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
40 ft lbs (55 Nm) 95 ft lbs (130 Nm) 170 ft lbs (230 Nm)
- Operation and Safety Manual 1
- FOREWORD 3
- Contact: 5
- Outside USA: 5
- REVISION LOG 6
- TABLE OF CONTENTS 10
- 1.1 GENERAL 11
- 1.2 PRE-OPERATION 11
- Workplace Inspection 12
- Machine Inspection 12
- Trip and Fall Hazards 13
- 1.3 OPERATION 13
- General 13
- Electrocution Hazards 14
- 3121214 – JLG Lift – 1-5 15
- Tipping Hazards 16
- 3121214 – JLG Lift – 1-7 17
- 1-8 – JLG Lift – 3121214 18
- 3121214 – JLG Lift – 1-9 19
- 1-10 – JLG Lift – 3121214 20
- 2.1 PERSONNEL TRAINING 21
- Operator Training 21
- Training Supervision 21
- Operator Responsibility 21
- MAINTENANCE 22
- Pre-Start Inspection 24
- Function Check 25
- 2-6 – JLG Lift – 3121214 26
- 3121214 – JLG Lift – 2-7 27
- 2-8 – JLG Lift – 3121214 28
- 3121214 – JLG Lift – 2-9 29
- 2-10 – JLG Lift – 3121214 30
- 3121214 – JLG Lift – 2-11 31
- 2-12 – JLG Lift – 3121214 32
- 3.1 GENERAL 33
- 3.2 CONTROLS AND INDICATORS 33
- Ground Control Station 33
- 3-2 – JLG Lift – 3121214 34
- 3121214 – JLG Lift – 3-3 35
- 3-4 – JLG Lift – 3121214 36
- 3121214 – JLG Lift – 3-5 37
- 3-6 – JLG Lift – 3121214 38
- Platform Control Station 39
- 3-8 – JLG Lift – 3121214 40
- 3121214 – JLG Lift – 3-9 41
- 3-10 – JLG Lift – 3121214 42
- 3121214 – JLG Lift – 3-11 43
- 3-12 – JLG Lift – 3121214 44
- 3121214 – JLG Lift – 3-13 45
- 3-14 – JLG Lift – 3121214 46
- SECTION 4. MACHINE OPERATION 47
- Stability 48
- 4.3 MOTOR OPERATION 48
- Power/Emergency Stop 48
- Platform/Ground Select Switch 48
- SECTION 4 - MACHINE OPERATION 49
- Motor Activation 51
- 4.4 TRAVELING (DRIVING) 51
- Traveling Forward and Reverse 52
- 4.5 STEERING 52
- 4.6 PLATFORM 52
- Loading From Ground Level 52
- Platform Level Adjustment 54
- Platform Rotation 54
- 4.7 BOOM 54
- Swinging the Boom 55
- 4.8 BOOM FUNCTION SPEEDS 55
- 4.9 SHUT DOWN AND PARK 56
- 4.10 LIFTING AND TIE DOWN 56
- Tie Down 56
- 5.1 GENERAL 79
- 5.2 INCIDENT NOTIFICATION 79
- 5.3 EMERGENCY OPERATION 80
- 5.5 MANUAL DESCENT SYSTEM 81
- Jib Manual Descent 81
- Manual Swing Override 81
- 5-4 – JLG Lift – 3121214 82
- 6.1 INTRODUCTION 83
- 6.2 OPERATING SPECIFICATIONS 83
- 6-2 – JLG Lift – 3121214 84
- Capacities 85
- 6-4 – JLG Lift – 3121214 86
- 3121214 – JLG Lift – 6-5 87
- Critical Stability Weights 88
- Serial Number Locations 88
- 3121214 – JLG Lift – 6-7 89
- 6.3 OPERATOR MAINTENANCE 90
- 3121214 – JLG Lift – 6-9 91
- 6-10 – JLG Lift – 3121214 92
- 3121214 – JLG Lift – 6-11 93
- Battery Charging, Daily 94
- 6.5 TIRES AND WHEELS 95
- Tire Wear and Damage 95
- Wheel and Tire Replacement 95
- Wheel Installation 95
- 6.6 SUPPLEMENTAL INFORMATION 96
- 3121214 – JLG Lift – 7-1 97
- 7-2 – JLG Lift – 3121214 98
- JLG Worldwide Locations 100
Produits connexes et manuels pour Machines spéciales Jlg E300 Operator Manual
(264 pages)
(106 pages)
(116 pages)
(158 pages)
(48 pages)
(124 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.410 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels