Jlg 41AM Operator Manual Manuel d'utilisateur télécharger pdf (Page 63)

SECTION 4 - MACHINE OPERATION

3121211 – JLG Lift – 4-19

Pickup Truck Loading Device (Option)

(See Figure 4-11.)

NOTE: The stowed mast height of the 36AM and 41AM exceeds

the length of most pick-up truck beds. JLG does not rec-

ommend transporting those models by pick-up truck.

AM model machines can be transported in a standard full size

pickup truck. If the machine is equipped with the loading device

option, it can be loaded and unloaded by one person.

NOTE: For a smooth rolling surface and even weight distribution,

it is recommended that 3/4" to 1" (2 to 2.5cm) thick ply-

wood be placed in the truck bed and out onto the tailgate.

This should avoid tailgate damage.

Park truck on a firm, smooth, level surface with the tailgate

open. Remove the battery/charger storage box from DC model

machines.

1. Set load pivot bar on back of mast so bar is set approx-

imately 1 - 2 in (3 to 5 cm) above tailgate height. Use

the spring loaded locking pin to raise or lower the load

pivot bar. Once bar is locked in place, push machine

against the tailgate.

2. At front of the machine, extend the T-handle lifting bar

from the base frame.

3. Begin lifting the machine onto the tailgate of the truck

with the T-handle lifting bar. As machine begins to

pivot be certain the load pivot bar is engaging the

truck tailgate.

4. Continue lifting and pushing machine onto the truck

bed, firmly grasp the machine by the base frame

pushing it all the way into truck bed.

5. Secure machine to the truck bed with rope or tie down

hooks to limit any machine movement while trans-

porting.

To unload machine from truck bed, reverse loading instructions

above.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 97 98

Pas de commentaire

Jlg 41AM Operator Manual Manuel d'utilisateur Page 63