Jlg 1100SJP Operator Manual Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 130
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
SECTION 1 - SAFETY PRECAUTIONS
3121255 – JLG Lift – 1-3
1.3 OPERATION
General
Do not use the machine for any purpose other than posi-
tioning personnel, their tools, and equipment.
Never operate a machine that is not working properly. If a
malfunctions occurs, shut down the machine.
Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and
stop before moving the switch to the next function. Oper-
ate controls with slow and even pressure.
Hydraulic cylinders should never be left fully extended or
fully retracted before shutdown or for long periods of time.
Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
Do not carry materials directly on platform railing. Contact
JLG for approved material handling accessories.
When two or more persons are in the platform, the opera-
tor shall be responsible for all machine operations.
Always ensure that power tools are properly stowed and
never left hanging by their cord from the platform work
area.
Supplies or tools which extend outside the platform are
prohibited unless approved by JLG.
When driving, always position boom over rear axle in line
with the direction of travel. Remember, if boom is over the
front axle, steer and drive functions will be reversed.
Do not assist a stuck or disabled machine by pushing,
pulling, or by using boom functions. Only pull the unit
from the tie-down lugs on the chassis.
Do not place boom or platform against any structure to
steady the platform or to support the structure.
Stow boom and shut off all power before leaving machine.
Trip and Fall Hazards
During operation, occupants in the platform must wear a full
body harness with a lanyard attached to an authorized lan-
yard anchorage point. Attach only one (1) lanyard per lan-
yard anchorage point.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 129 130

Commentaires sur ces manuels

Pas de commentaire