Jlg 680S Operator Manual Manuel d'utilisateur Page 117
- Page / 128
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
SECTION 6 - GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
3121233 – JLG Lift – 6-33
3. The tightening of the nuts should be done in stages. Fol-
lowing the recommended sequence, tighten nuts per
wheel torque chart.
4. Wheel nuts should be torqued after first 50 hours of opera-
tion and after each wheel removal. Check torque every 3
months or 150 hours of operation.
6.6 DRAINING OIL BUILD UP FROM THE
PROPANE REGULATOR (PRIOR TO S/N
0300134626)
During the course of normal operation oils may build inside
the primary and secondary chambers of the propane pres-
sure regulator. These oils may be a result of poor fuel quality,
contamination of the fuel supply chain, or regional variation
in the make up of the fuel. If the build up of the oil is signifi-
cant this can effect the operation of the fuel control system.
Refer to Section 6.4, Operator Maintenance for maintenance
intervals. More frequent draining may be required if the fuel
supply has been contaminated.
FOR BEST RESULTS WARM THE ENGINE TO OPERATING TEMPERA-
TURE BEFORE DRAINING. THIS WILL ALLOW THE OILS TO FLOW
FREELY FROM THE REGULATOR.
1. Move the equipment to a well ventilated area. Ensure
there are no external ignition sources.
2. Start the engine and bring to operating temperature.
3. With the engine running, close the manual tank valve
and run the engine out of fuel.
Table 6-19. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
70 ft. lbs.
(95 Nm)
170 ft. lbs.
(225 Nm)
300 ft. lbs.
(405 Nm)
- Operation and Safety Manual 1
- FOREWORD 3
- Contact: 5
- Outside USA: 5
- REVISION LOG 6
- TABLE OF CONTENTS 10
- 1.1 GENERAL 11
- 1.2 PRE-OPERATION 11
- Workplace Inspection 12
- Machine Inspection 12
- 1.3 OPERATION 13
- General 13
- Trip and Fall Hazards 13
- Electrocution Hazards 14
- 3121233 – JLG Lift – 1-5 15
- Tipping Hazards 16
- 3121233 – JLG Lift – 1-7 17
- 1-8 – JLG Lift – 3121233 18
- 3121233 – JLG Lift – 1-9 19
- 1-10 – JLG Lift – 3121233 20
- 2.1 PERSONNEL TRAINING 21
- Operator Training 21
- Training Supervision 21
- Operator Responsibility 21
- MAINTENANCE 22
- 3121233 – JLG Lift – 2-3 23
- Pre-Start Inspection 24
- Function Check 25
- 2-6 – JLG Lift – 3121233 26
- 3121233 – JLG Lift – 2-7 27
- 2-8 – JLG Lift – 3121233 28
- 3121233 – JLG Lift – 2-9 29
- SWITCHES 30
- 3121233 – JLG Lift – 2-11 31
- 2-12 – JLG Lift – 3121233 32
- 3121233 – JLG Lift – 2-13 33
- EQUIPPED) 34
- 3121233 – JLG Lift – 2-15 35
- 2-16 – JLG Lift – 3121233 36
- 3.1 GENERAL 37
- 3.2 CONTROLS AND INDICATORS 37
- Ground Control Station 37
- 3-2 – JLG Lift – 3121233 38
- 3121233 – JLG Lift – 3-3 39
- 3-4 – JLG Lift – 3121233 40
- 3121233 – JLG Lift – 3-5 41
- 3-6 – JLG Lift – 3121233 42
- 3121233 – JLG Lift – 3-7 43
- Platform Station 44
- 3121233 – JLG Lift – 3-9 45
- 3-10 – JLG Lift – 3121233 46
- 3121233 – JLG Lift – 3-11 47
- 3-12 – JLG Lift – 3121233 48
- 3121233 – JLG Lift – 3-13 49
- 3-14 – JLG Lift – 3121233 50
- 3121233 – JLG Lift – 3-15 51
- 3-16 – JLG Lift – 3121233 52
- 3121233 – JLG Lift – 3-17 53
- 3-18 – JLG Lift – 3121233 54
- 3121233 – JLG Lift – 3-19 55
- 3-20 – JLG Lift – 3121233 56
- SECTION 4. MACHINE OPERATION 57
- 4.3 ENGINE OPERATION 58
- Starting Procedure 58
- Shutdown Procedure 59
- SECTION 4 - MACHINE OPERATION 60
- 4.4 TRAVELING (DRIVING) 61
- Traveling Forward and Reverse 62
- 4.5 STEERING 62
- Platform Level Adjustment 64
- Platform Rotation 64
- 4.7 BOOM 64
- 4.6 PLATFORM 64
- Swinging the Boom 65
- Raising and Lowering the Boom 65
- 4.8 FUNCTION SPEED CONTROL 65
- 4.10 EMERGENCY TOWING 66
- 4.11 TOW BAR (IF EQUIPPED) 67
- 4.12 SHUT DOWN AND PARK 69
- 4.13 LIFTING AND TIE DOWN 69
- Tie Down 70
- 5.1 GENERAL 81
- 5.2 INCIDENT NOTIFICATION 81
- 5.3 EMERGENCY OPERATION 81
- To Retract and Lower Boom 83
- 5-4 – JLG Lift – 3121233 84
- 6.1 INTRODUCTION 85
- 6.2 OPERATING SPECIFICATIONS 85
- 6-2 – JLG Lift – 3121233 86
- Capacities 87
- Engine Data 88
- 3121233 – JLG Lift – 6-5 89
- 6-6 – JLG Lift – 3121233 90
- 3121233 – JLG Lift – 6-7 91
- 6-8 – JLG Lift – 3121233 92
- 3121233 – JLG Lift – 6-9 93
- 6.3 SERIAL NUMBER LOCATION 94
- 3121233 – JLG Lift – 6-11 95
- 6-12 – JLG Lift – 3121233 96
- 6-14 – JLG Lift – 3121233 98
- AMBIENT AIR 99
- TEMPERATURE 99
- 6-16 – JLG Lift – 3121233 100
- 4150548-E 101
- 6-18 – JLG Lift – 3121233 102
- 6-20 – JLG Lift – 3121233 104
- 6.4 OPERATOR MAINTENANCE 105
- 6-22 – JLG Lift – 3121233 106
- 3121233 – JLG Lift – 6-23 107
- 6-24 – JLG Lift – 3121233 108
- 3121233 – JLG Lift – 6-25 109
- 6-26 – JLG Lift – 3121233 110
- 3121233 – JLG Lift – 6-27 111
- 6-28 – JLG Lift – 3121233 112
- 3121233 – JLG Lift – 6-29 113
- 6.5 TIRES & WHEELS 114
- Tire Inflation 114
- Tire Damage 114
- Tire Replacement 115
- Wheel Replacement 115
- Wheel Installation 116
- 0300134626) 117
- 6-34 – JLG Lift – 3121233 118
- Installation 119
- 6-36 – JLG Lift – 3121233 120
- 6.9 SUPPLEMENTAL INFORMATION 121
- 6-38 – JLG Lift – 3121233 122
- 3121233 – JLG Lift – 7-1 123
- 7-2 – JLG Lift – 3121233 124
- TRANSFER OF OWNERSHIP 125
- JLG Worldwide Locations 128
Produits connexes et manuels pour Machines spéciales Jlg 680S Operator Manual
(130 pages)
(98 pages)
(438 pages)
(148 pages)
(88 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.707 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels